Collaborate Disseminate
I’ve been struggling with an issue on a quite simple task…
I’m trying to set up an access point with a captive portal. I can go as far as seeing the AP from the test device (my smartphone) but it says "Cannot resolve IP address"… Continue reading dnsmasq fails when I’m trying to make a fake access point with captive portal [closed]
I am attempting to use a Raspberry Pi Model B+ as a WiFi access point with the IP address of 192.168.0.1. This access point should redirect all HTTP and HTTPS traffic to a different machine with the IP address of 192.168.0.29 on port 8080…. Continue reading How to configure RPi to work as wifi access point that uses a Burp as a proxy? [migrated]
I would like to be able to switch back and forth between the real DNS and maybe setting a local DNS entry so I can manipulate AJAX responses for code security checks.
For instance if the server responds with Ajax on page 1 that page 2 is n… Continue reading How can I manipulate certain server side responses? Specifically Ajax Responses? XXE Attack? Hybrid DNS Resolution?
I set up OpenWRT on my Belkin RT3200 and I want to have quad9 encrypted DNS with dnssec and Secure SNI, but I could not figure out how to set up DNScrypt correctly on my router and I’m not sure if that’s the best method.
I’d like to avoid … Continue reading How to set up DNS encryption on my home router? [migrated]
I am using a DNS forwarder, it’s not open to the WWW (runs only in the LAN) and in the dnsmasq logs I noticed something off:
Ignoring query from non-local network
Has my network been breached?
Dnsmasq is running on Pi-Hole with most of th… Continue reading Should I be worried about Ignoring query from non-local network in dnsmasq?
I have an Host A where I have my VM running Kali and Host B, which is a Win computer.
I want to have Host A as the only one computer connected to the Internet, so Host B must pass through Host A via an Ethernet cable in order to connect.
H… Continue reading DNSMASQ set up – Connecting two computers over a Ethernet cable [migrated]
I have an Host A where I have my VM running Kali and Host B, which is a Win computer.
I want to have Host A as the only one computer connected to the Internet, so Host B must pass through Host A via an Ethernet cable in order to connect.
H… Continue reading DNSMASQ set up – Connecting two computers over a Ethernet cable [migrated]
I want to establish a point to point connection between two machines on my LAN, a Win machine and a Kali machine (running as VM) connected with a cross Ethernet cable.
The goal is to set up a dnsmasq configuration that will allow to config… Continue reading Set up a DNS/DHCP server with dnsmasq – Point to point connection [closed]
I ran an nmap scan on my home network and linux machine. There were a few suspicious ports open so I used the command netstat -tanp|grep LISTEN to investigate further. The output was that dnsmasq is listening on port 53. Why when I run the… Continue reading Is dnsmasq using port 53 a vulnerability? [migrated]
I’m using hostapd to setup a wireless access point and dnsmasq as a DNS/DHCP server. I defined in dnsmasq to reply with the IP of the access point (10.0.10.1) when it receives a query for www.messenger.com. Using the setoolkit, I’m hosting… Continue reading DNS spoofing protection in Chrome and Firefox