Issues with wlan0 in kali and getting airodump-ng to work [duplicate]
As you can see my adapter is enabled for monitor mode but airodump-ng is not working.
Continue reading Issues with wlan0 in kali and getting airodump-ng to work [duplicate]
Collaborate Disseminate
As you can see my adapter is enabled for monitor mode but airodump-ng is not working.
Continue reading Issues with wlan0 in kali and getting airodump-ng to work [duplicate]
As you can see my adapter is enabled for monitor mode but airodump-ng is not working.
Continue reading Issues with wlan0 in kali and getting airodump-ng to work [duplicate]
I was using Alfa awus1900 (Realtek 8814u) wifi adapter to test my wifi but from this point, it always shows fixed channel -1 while scanning a particular bssid and on deuath also and after using –ig to ignore -ve one also it is not effecti… Continue reading Fixed Channel : -1 ( in Scanning and deauth)
I’m trying to decrypt my home wifi traffic with wireshark but I can’t get any good result even tough I setup the password in IEEE802.11 and I checked that eapol handshake is present in the captured traffic.
first step: enable monitor mode… Continue reading Unable to decrypt captured traffic in Wireshark with EAPOL+PWD
I use the TP-Link T9UH Archer v2 wireless adapter and until yesterday it was working perfectly with packet injection and other attacks. But today when I tried to enter monitor mode it succeeded but ifconfig no longer showing me the informa… Continue reading Monitor mode no longer works [migrated]
Equipment: Alfa AWUS036ACH Wi-Fi adapter AC1200
Fresh Install of Kali Linux, fully updated (not on a VM)
I have been running across this same "bad beacon" error (sometimes with "DEAUTH" in front of it) when trying to ru… Continue reading besside-ng "bad beacon" error when attempting to deauth (aircrack-ng)
I wish to run airodump-ng run a set period of time on a Raspberry Pi running Raspbian Buster.
I’ve researched here and elsewhere and tried this:
timeout 10 sudo airodump-ng wlan1mon
… but the process still runs after 10 seconds and does… Continue reading How to make timeout work with airodump-ng on raspberry pi running buster?
I tried to monitor specified WIFI connection, i typed
airodump-ng –bssid <My target’s bssid> –channel 19
and when i run it, opens help page!
and not monitoring this connection…
Please help!
I opened two terminals:
airodump-ng –bssid router mac –channel 6 wlan0
and
aireplay-ng –deauth 10000000 –a Router mac –c device mac wlan0
The result:
attack mode already specified
Continue reading "Attack mode already specified" error in aireplay-ng
recently I discovered airodump-ng and aireplay-ng for deauthing purposes, and there were many clients under the stations section (in airodump-ng). I want to know how I can see the device manufacterer from the mac addresses. I can see this … Continue reading How to find device manufacterer from MAC in airodump-ng [closed]