Category Archives: odroid

Hackaday Links: June 24, 2018

Posted on by

What do you do if you’re laying out a PCB, and you need to jump over a trace, but don’t want to use a via? The usual trick is using a zero Ohm resistor to make a bridge over a PCB trace. Zero Ohm resistors — otherwise known as ‘wire’ — are a handy tool for PCB designers who have backed themselves into a corner and don’t mind putting another reel on the pick and place machine. Here’s a new product from Keystone that is basically wire on a tape and reel. It’s designed to jump traces on a PCB …read more

Continue reading Hackaday Links: June 24, 2018→

Neat Odroid & GlusterFS Build Stashes Data, Sips Power

Posted on by

Most of us accumulate stuff, like drawers full of old cables and hard drives full of data. Reddit user [BaxterPad] doesn’t worry about such things though, as he built an impressive Network Attached Storage (NAS) system that can hold over 200TB of data. That’s impressive enough, but the real artistry is in how he did this. He built this system using ODroid HC2 single board computers running GlusterFS, combining great redundancy with low power usage.

The Odroid HC2 is a neat little single board computer that offers a single SATA interface and runs Linux. [BaxterPad] acquired sixteen of these, and …read more

Continue reading Neat Odroid & GlusterFS Build Stashes Data, Sips Power→

ODROID XU4 Runs Cool as Water

Posted on by

We did a bit of looking through the ODROID forums and apparently it’s quite possible to squeeze an impressive amount of performance out of these little single board computers, if you don’t mind them getting boiling hot.

Now, some people have taken pedestrian routes. It’s a low power single board computer after all. A bigger heatsink or a fan appears to be enough for most. [Micky] and a friend, however, decided this is a problem that can only be solved with a healthy bit of overengineering.

Using a water cooler meant for a full CPU, a modified chipset cooling block …read more

Continue reading ODROID XU4 Runs Cool as Water→

ArduCAM Introduces A Third Party Raspberry Pi

Posted on by

There are hundreds of ARM-based Linux development boards out there, with new ones appearing every week. The bulk of these ARM boards are mostly unsupported, and in the worst case they don’t work at all. There’s a reason the Raspberry Pi is the best-selling tiny ARM computer, and it isn’t because it’s the fastest or most capable. The Raspberry Pi got to where it is today because of a huge amount of work from devs around the globe.

Try as they might, the newcomer fabricators of these other ARM boards can’t easily glom onto the popularity of the Pi. Doing …read more

Continue reading ArduCAM Introduces A Third Party Raspberry Pi→