Category Archives: MOARstruder

Hackaday Links: January 29, 2017

Posted on by

A 3D printer and laser cutter were cited as cause in two deaths. A couple (and two cats) were found dead in their apartment this week. The cause of death was carbon monoxide poisoning. Police and the gas company investigated the residence and found no other source of carbon monoxide besides a 3D printer and a laser cutter. Be sure to check out the people who know more about these deaths than the people who actually investigated these deaths in the comments below. In the mean time, get a CO detector. It’s nasty stuff.

At CES last this month, Lulzbot …read more

Continue reading Hackaday Links: January 29, 2017→

CES2017: Lulzbot Has the Best Names for Stuff

Posted on by

Lulzbot is the poster child of the RepRap project. Everything they do is big-O Open. At CES, Lulzbot launched the MOARstruder, a tool head with a 1.2mm nozzle diameter. That pushes a lot of plastic out, allowing for faster print times. This is the same nozzle diameter as the largest E3D Volcano, and from the big prints sitting around the booth, the results are similar: you get faster prints at larger layer heights, and the layer lines become a design feature.

Also announced by Lulzbot this week is the release of Cura 2 (Lulzbot edition), a partnership with the Blender  …read more

Continue reading CES2017: Lulzbot Has the Best Names for Stuff→