An Impressive Modular Mold Box

Prolific maker and product designer [Eric Strebel] has years of experience making reusable mold boxes for silicone and resin casting. He’s always used 3/4″ plywood before, but it comes with some problems such as inaccuracy, screws that eventually slip out, and no room at all for expansion. Now [Eric] has …read more

Continue reading An Impressive Modular Mold Box

These 3D Printed Supports Can Take Hard Use, Thanks to Resin Filling

Liquid two-part resins that cure into a solid are normally used for casting, and [Cuddleburrito] also found them useful to add strength and rigidity to 3D printed pillar supports. In this case, the supports are a frame for some arcade-style buttons, which must stand up to a lot of forceful mashing. Casting the part entirely out of a tough resin would require a mold, and it turns out that filling a 3D print with resin gets comparable benefits while making it easy to embed fastener hardware, if done right.

Filling the inside of an object with some kind of epoxy …read more

Continue reading These 3D Printed Supports Can Take Hard Use, Thanks to Resin Filling

Sacrificial Bridge Avoids 3D Printed Supports

[Tommy] shares a simple 3D printing design tip that will be self-evident to some, but a bit of a revelation to others: the concept of a sacrificial bridge to avoid awkward support structures. In the picture shown, the black 3D print has small bridges and each bridge has a hole. The purpose of these bits is to hold a hex nut captive in the area under the bridge; a bolt goes in through the round hole in the top.

Readers familiar with 3D printing will see right away that printing the bridges might be a problem. When a printer gets …read more

Continue reading Sacrificial Bridge Avoids 3D Printed Supports