NASA Claims Cold Fusion without Naming It

Do you remember in 1989 when two chemists announced they’d created a setup that created nuclear fusion at room temperature? Everyone was excited, but it eventually turned out to be very suspect. It wasn’t clear how they detected that fusion occurred and only a few of the many people who …read more

Continue reading NASA Claims Cold Fusion without Naming It→

Cheap Current Probe Gets Good Review

A current probe isn’t a very common fixture on most workbenches because they are pretty expensive. [VoltLog] looks at a fairly inexpensive current probe from Micsig. He seemed impressed with the workmanship and it looks similar to more expensive offerings. There are two models with different bandwidth numbers (800 kHz …read more

Continue reading Cheap Current Probe Gets Good Review→

Robotic Worm uses NinjaFlex Filament

If you think about building a moving machine, you probably will consider wheels or tracks or maybe even a prop to take you airborne. When [nwlauer] found an earthworm in the garden, it inspired a 3D-printed robot that employs peristaltic motion. You can see a video of it moving, below. …read more

Continue reading Robotic Worm uses NinjaFlex Filament→

Plaster Annealing 3D Prints for Strength

[Stefan] is always trying to make stronger 3D prints. Annealing can strengthen prints, but often at the expense of the part’s exact dimensions. His latest approach is to embed the prints in plaster and then anneal in an attempt to fuse the plastic together without changing its shape or size. …read more

Continue reading Plaster Annealing 3D Prints for Strength→

ESP32 Vulnerability affects Older Chips

There is a scene from the movie RED (Retired, Extremely Dangerous) where Bruce Willis encounters a highly-secure door with a constantly changing lock code deep inside the CIA. Knowing the lock would be impossible to break, he simply destroyed the wall next to the door, reached through, and opened the …read more

Continue reading ESP32 Vulnerability affects Older Chips→

Reforming 3D Prints with Salt and Heat

The biggest problem with fused deposition 3D prints is that while the layers should stick together, they aren’t the same as a solid piece of plastic you would get from, say, injection molding. You can anneal plastic using moderate heat, but it is likely to cause the part to deform …read more

Continue reading Reforming 3D Prints with Salt and Heat→

Upcycled Dryer Motor Makes Budget Disk Sander

At the most basic level, most shop tools are just a motor with the right attachments. But the details are often far from simple. [DuctTapeMechanic] took a junker clothes dryer, yanked the electric motor from it, and converted it into a disk sander. The price was right at about $10. …read more

Continue reading Upcycled Dryer Motor Makes Budget Disk Sander→