Category Archives: transportation hacks

Make Cars Safer By Making Them Softer

Posted on by

Would making autonomous vehicles softer make them safer?

Alphabet’s self-driving car offshoot, Waymo, feels that may be the case as they were recently granted a patent for vehicles that soften on impact. Sensors would identify an impending collision and adjust ‘tension members’ on the vehicle’s exterior to cushion the blow. These ‘members’ would be corrugated sections or moving panels that absorb the impact alongside the crumpling effect of the vehicle, making adjustments based on the type of obstacle the vehicle is about to strike.

The new reality of self driving vehicles has had people anxious over safety concerns with good …read more

Continue reading Make Cars Safer By Making Them Softer→

Ultrasonic Array Gets Range Data Fast and Cheap

Posted on by

How’s your parallel parking? It’s a scenario that many drivers dread to the point of avoidance. But this 360° ultrasonic sensor will put even the most skilled driver to shame, at least those who pilot tiny remote-controlled cars.

Watch the video below a few times and you’ll see that within the limits of the test system, [Dimitris Platis]’ “SonicDisc” sensor does a pretty good job of nailing the parallel parking problem, a driving skill so rare that car companies have spent millions developing vehicles that do it for you. The essential task is good spatial relations, and that’s where SonicDisc …read more

Continue reading Ultrasonic Array Gets Range Data Fast and Cheap→

ESP8266 Adds Slick Touchscreen Controls to a Stretch Limo

Posted on by

The popularity of the ESP8266 WiFi module has a lot to do with its ability to inexpensively connect to the Internet. However, [hwhardsoft]’s stretch limousine environmental control system explores another use for these modules: a simple way to tie together disparate systems with a common user interface.

On a basic level, the problem is one we’ve all faced: multiple devices with multiple control interfaces create an awkward user experience. Have you ever worked in an office with 6 brands of air conditioner requiring 6 different remotes? Because of its low-cost, support for Wi-Fi, serial, and GPIO, ESP8266 boards are a …read more

Continue reading ESP8266 Adds Slick Touchscreen Controls to a Stretch Limo→

Mini Oscar Mayer Wienermobile Takes Moxie in KC

Posted on by

There are no shortage of fantastic and creative Power Racing Series cars, but here’s an especially fun example. [Pete Prodoehl] of Milwaukee Makerspace and his teammates [Kathy Cannistra] and [Kyle White] built a Power Racing car based on the design of the iconic Oscar Mayer Wienermobile.

They created the wienie and bun out of fiberglass and foam. Meanwhile, with the KC Maker Faire approaching, the team scrambled to finish the project, with [Kyle] working on assembly while [Pete] tackled the electronics. [Kyle] also proved to be the best wiener rider, with everyone else getting thrown off.

It should be noted …read more

Continue reading Mini Oscar Mayer Wienermobile Takes Moxie in KC→

Possibly the Most Up-Cycled, Hacked E-Bike You’ll See All Week

Posted on by

When it comes to bringing an idea to life it’s best to have both a sense of purpose, and an eagerness to apply whatever is on hand in order to get results. YouTube’s favorite Ukrainians [KREOSAN] are chock full of both in their journey to create this incredible DIY e-bike using an angle grinder with a friction interface to the rear wheel, and a horrifying battery pack made of cells salvaged from what the subtitles describe as “defective smartphone charging cases”.

What’s great to see is the methodical approach taken to creating the bike. [KREOSAN] began with an experiment consisting …read more

Continue reading Possibly the Most Up-Cycled, Hacked E-Bike You’ll See All Week→

DIY Electric Beach Luge is a Thrill

Posted on by

[John Dingley] describes his Electric Beach Luge Project as an exciting mashup between “a downhill luge board, a kite surf buggy, a go-kart, and a Star Wars Land Speeder” and it’s fresh from a successful test run. What’s not to like? The DIY experimental vehicle was made to run on long, flat, firm stretches of sand while keeping the rider as close to the ground as possible. The Beach Luge is mainly intended to be ridden while lying on one’s back, luge-style, but it’s also possible to lay prone in the “Superman” position.

The whole unit was built from the …read more

Continue reading DIY Electric Beach Luge is a Thrill→

So, You’ve Never Made A Spaceframe Before

Posted on by

It is sometimes a surprise in our community of tinkerers, builders, hackers, and makers, to find that there are other communities doing very similar things to us within their own confines, but in isolation to ours. A good example are the modified vehicle crowd. In their world there are some epic build stories and the skills and tools they take for granted would not in any way be unfamiliar to most Hackaday readers.

As part of a discussion about electric vehicles near where this is being written, someone tossed an interesting link from that quarter into the mix; a two-part …read more

Continue reading So, You’ve Never Made A Spaceframe Before→

Electric Longboard with All-New Everything

Posted on by

We love [lolomolo]’s Open Source electric longboard project. Why? Because he completely re-engineered everything while working on the project all through college. He tackled each challenge, be it electronic or mechanical as it came, and ended up making everything himself.

The 48″ x 13″ deck is a rather unique construction utilizing carbon fiber and Baltic birch. In testing the deck, [lolomol] found the deflection was less than an inch with 500 lbs. on the other end. He modified the Caliber II trucks to add four 2250W Turnigy Aerodrive brushless outrunners driving the wheels with the help of belts. The motors …read more

Continue reading Electric Longboard with All-New Everything→

Open Source Modular Rocket Avionics Package

Posted on by

Cambridge postgraduate student [Adam Greig] helped design a rocket avionics system consisting of a series of disc-shaped PCBs arranged in a stack. There’s a lot that went into the system and you can get a good look at it all through the flickr album.

Built with the help of Cambridge University Spaceflight, the Martlet is a 3-staging sounding rocket that lifts to 15km/50K feet on Cesaroni Pro98 engines. [Adam]’s control system uses several Arm Cortex M4s on various boards rather than having just one brain controlling everything.

Each disc is a module that plays a specific role in the system. …read more

Continue reading Open Source Modular Rocket Avionics Package→

Amphibious Houseboat Hits the Open Road

Posted on by

What’s better than having your own houseboat? How about an amphibious houseboat? That’s exactly what [Theon Parseghian] is building in his driveway. It all started with a derelict 32-foot long houseboat. A 1967 model with a rusted steel hull, [Theon] originally bought it as a guest house.

[Theon] couldn’t let the boat rust away in his back yard though. Quickly decided to get it back on the open water…. and on the road. An amphibious houseboat. While looking for large tractor tires, [Theon] found an entire crop sprayer which hadn’t been used in years. This crop sprayer was a giant …read more

Continue reading Amphibious Houseboat Hits the Open Road→